Jeep Key Fob Stuck In Ignition

It would not turn back to the stop where you can get the key out.
Jeep key fob stuck in ignition. Discussion in jeep renegade mechanical problems and questions. This has been an issue for about 4 5 months and of course has gotten progressively worse. If you don t hear it the spring might be loose or came off. The spring in the gear leaver mechanism might be loose.
Hi dave i have an 09 jeep grand cherokee and the key fob is stuck in the ignition and won t come out. If your jeep liberty s battery doesn t have enough voltage to properly engage the safety mechanisms that leave your key stuck in the ignition can cause the issue. How to get key unstuck. Faint but you should hear it.
Hello and welcome to just answer jeep. This is our recommended order to do them in. Make sure you have voltage. At first driver would need to turn the key to on start 1 3 times then shut vehicle down to get the mechanism to release the key fob.
I got back to my brother s house and shut off the jeep. I recommend trying to remove the key cylinder and take it to a lock smith or the dealer to have it replaced or rebuilt. Due to my concern with cost i have disconnected the battery and have parked it for a bit. Recently within the past 2 3 weeks this has occurred nearly.
I had been making a couple trips around town to run some errands. Turn on the jeep while in park tap the shifter knob to the right don t pull it down to r n d listen for a click sound. Here are ways that you can get your liberty s key free. Try this to check.
If your jeep has less than 36 000 miles it should still be covered under the basic warranty and this would be a covered item. Your key cylinder has probably jammed up. Be sure to follow this in order to avoid the key sticking in the ignition. Over the weekend my jeep had a problem.
After shifting into park and then releasing the brake pedal the vehicle requires a slight delay about 0 5 seconds before allowing the key to be removed from the ignition cylinder. Trailhawk but the turn key start renegades they have a reprogram for the ipc module and the real problem is the ignition switch housing not the key fob the down side to this is as i write this they are on a slight backorder from the supplier this is.